List of shared models

[gianfranco]

A couple of pedals by @Boukman

@Boukman

DemonFx TS9 K Clip.json (171.1 KB)
DRV 1981 Clone .json (170.6 KB)
Marshall Guvnor Plus.json (170.7 KB)
Strymon Deco G8.json (169.8 KB)
All the drive pedals are gain at half,except the Strymon which is a tape saturation with the gain at 3 o clock.
The DemonFx TS is at the TS9 setting with the clipping set to Keeley red dirt clipping.
The Guvnor plus has been modded to the original guvnor pedal.

[gianfranco]

Fender Twin Reberb (Vibrato Channel) and Fender Champ 5F1 Clone by @Boukman

@Boukman

Hi everyone!
I made a capture of my Fender Twin Reverb Vib channel (Silverface to Blackface conversion)
and my Champ 5F1 clone.
Hope you like them!
Champ G9.json (171.6 KB)
Fender Twin CH2.json (170.8 KB)

[gianfranco]

More pedals, by @Boukman

@Boukman

I made a few more pedal captures.Hope you like them!
They are all clones except the Bogner.
King of tone Clone Both.json (170.7 KB)
Protein CLone.json (170.5 KB)
Revv G3 g8.json (170.5 KB)
Supro Bold G9.json (170.7 KB)
Thorpy Peacekeeper.json (170.2 KB)
Bogner XTC High new.json (170.2 KB)
Bogner XTC Medium new.json (170.6 KB)
Colombo Plexi breed.json (170.9 KB)
Ethos TWE-1.json (170.4 KB)
JHS AT Clone 50w EP pre G6.json (170.7 KB)

[gianfranco]

Peavey VK100 HEAD HIGAIN Lead Channel by @ReedDunn

@ReedDunn

HI REED DUNN here with my First upload for MOD site!

ReedD VK100 personal setting.json (199.4 KB)

This is my second capture of my Vk100 this one is from my Neural Amp Modeler training NAM captures re trained for AIDA-X. More to Come.pretty heavy tone that i use on my amp.just past half for eq on sweet spots.and 3/4 for dampening and presence. lead channel with gain boost and volume boost.tube type dial is fully left for that extra power to the lead channel pre amp tubes. I hope you enjoy. only wish i have is for a noise gate in AIDA-X but i can easily use a fee one like GVST - GGate before AIDA-X works great.!!!KEEP IT LOUD!!!

[gianfranco]

Ceriatone King Kong - Part 3 (hotter) by @Boukman

@Boukman

Hi again!
I tried a few captures with hotter input signal.Let me know what you think
Ceriatone King Kong Channel 1 60s.json (170.3 KB)
KK new 60s br sw2 L .json (171.0 KB)
KK new 70s br sw2 L .json (170.9 KB)
KK new 80s br sw2 L .json (170.5 KB)

[gianfranco]

Ceriatone King Kong - Part 3 (boosted) by @Boukman

@Boukman

Hi!
I made a few more captures of my amp.I think they are getting better!I used some pedals in some captures to boost it.I`m really pleased with the sound!!
I think it sounds better than Line6 Helix already with the AIDA!!
Cheers!!

KK Ch2 Br sw both L feel dn 60s deep c bright R Lead 80s .json (170.5 KB)
KK Ch2 Br sw off feel dn 60s deep c bright r Guvnor boost - target.json (170.6 KB)
KK Ch2 Br sw both L feel dn 60s deep c bright R - target.json (170.5 KB)
KK CH2 Brsw both L feel dn 70s deep C bright R.json (170.9 KB)
KK Ch2 G1 Br sw L 70s deep c bright R Feel Up Hudson Broadcast.json (170.7 KB)

@Boukman

KK Ch1 Br sw L 60s deep c bright R boost SD.json (170.8 KB)
KK Ch2 G1 Br sw L 80s deep c bright R Feel Up.json (170.7 KB)
KK Ch2 G1 Br sw L 60s deep c bright R Feel Up DemonTS9 K.json (170.7 KB)
KK Ch1 Br sw L 60s deep c bright R Protein - .json (170.2 KB)
KK Ch1 Br sw L 60s deep c bright R Barber DD.json (170.7 KB)

[gianfranco]

Full “channel strip” for Electric Nylon Guitar by @Loris_Donatelli

@Loris_Donatelli

This is taken from the Logic settings, it’s my “channel strip” and is useful for a classical guitar sound, when the nylon string instrument has no microphone but only a piezo system. The reverb is already present, if someone wants it without I will do it again without so that you can choose the right reverb. Currently there is only EQ and COMP.
Electric Nylon Guitar.json (172.2 KB)

[gianfranco]

Victory Countess (The Jack) V4 Preamp by @Boukman

@Boukman

Here are some profiles of my tube preamp clean and drive channels at various gain settings.
Try using the power amp impulses plugin after.It works really nice!!
Victory Countess V4 Ch1 G 4 .json (171.2 KB)
Victory Countess V4 Ch2 G full.json (170.2 KB)
Victory Countess V4 Ch2 G 3q .json (170.5 KB)
Victory Countess V4 Ch2 Gain Half.json (170.6 KB)
Victory Countess V4 Ch2 Gain 1Q.json (170.8 KB)

@Boukman

Victory Countess V4 Ch1 G 9.json (170.8 KB)
Victory Countess V4 Ch1 G 6.json (170.9 KB)

@Boukman

I made this with lower gain…I think they sound clearer…
Victory V4 CH2 Gain 7.5 di 5 -11 lower esr.json (170.4 KB)
Victory V4 CH2 Gain 3 di 5 -11 - .json (170.5 KB)

[gianfranco]

Catalinbread DLS (Marshall Plexi Super Bass) by @novemberist

@novemberist

This is a model of my Catalinbread Dirty Little Secret pedal, which basically emulates the sound and character of a classic Marshall Plexi amp (set to “Super Bass” circuit in my case). I’ve chosen the lightest model for this one and have sampled 4 different degrees of the preamp knob (low,center,high,very high). No cab simulation of any kind included.

CB_DLS_Preamp_Low.json (15.7 KB)
CB_DLS_Preamp_Center.json (15.7 KB)
CB_DLS_Preamp_High.json (15.7 KB)
CB_DLS_Preamp_VeryHigh.json (15.7 KB)

[gianfranco]

AX84 P1 DIY Amp - Amp Only by @mreed707

@mreed707

Single 12AX7 and a single EL34 amp. Marshall sounding JTM ish. Set up as a pedal platform so just a little bit of break up. DI through Two Notes Captor into Logic. Guitar used, Fender Mustang with humbuckers so pushing the front a bit more than a single coil.
Clean AX84 P1.json (81.4 KB)

[gianfranco]

Fender Twin Reverb by @Boukman

@Boukman

I made a capture using the TS808 a la SRV.
Fender Twin Reverb TS808 g-11 di half .json (171.1 KB)

[gianfranco]

Fender Twin Reverb and Champ by @Boukman

@Boukman

I made a capture of my Fender Twin Reverb Vib channel (Silverface to Blackface conversion)
and my Champ 5F1 clone.
Hope you like them!
Champ G9.json (171.6 KB)
Fender Twin CH2.json (170.8 KB)

[gianfranco]

Boss Katana Mini - 3 Channels by @novemberist

@novemberist

this one is obviously more for fun and probably not very useful for most of you. But I think the model sounds quite good - like the real Mini. Captured with Mid-Gain on the 3 available channels (Clean,Crunch,Brown) respectively. EQ-knobs all at 12 o’clock.

Boss_Katana_Mini_Clean.json (15.7 KB)
Boss_Katana_Mini_Crunch.json (15.7 KB)
Boss_Katana_Mini_Brown.json (15.7 KB)

[gianfranco]

BASS: Darkglass AO900 by @Charan_Mellor

@Charan_Mellor

Here are three light models of the preamp section of my Darkglass AO900
All knobs set to ~noon, EQ flat

Enjoy!

DGAO900-clean_LSTM-12-0.json (32.5 KB)
DGAO900-dirty-light drive_LSTM-12-0.json (32.0 KB)
DGAO900-dirty-med drive_LSTM-12-0.json (32.3 KB)

[gianfranco]

Marshal JMP Low Sensitivity Input - Pedal platform, clean. by @mreed707

Two Notes Captor
Sounds great with Guitarix Gxcabinet 4x12 with treble set at 10 o’clock.
Heavy - ESR 0.003 (on third attempt, the first 2 were 0.011 - didn’t change anything just kept running the cell)
A/B against real amp very very close, amazed.
Sounds great with DIY OCD, Rat and TS-9
JMP Low Input.json (81.5 KB)

Did this sound good to you

[gianfranco]

Diplomacy by @LievenDV

@LievenDV

Diplomacy
Version 3 (3rd attempt, best result so far)
High gain amp, modelled after the free amp VST:
Ignite Emissary (STL Tones), a loud metal machine!

@LievenDV

Diplomacy-amp-high-gain.json (53.5 KB)

[gianfranco]

“Schmitt | based on Bogner Uberschall rev blue” by @LievenDV

@LievenDV

I modelled a SVT representation of the Bogner Uberschall rev. blue.
Little noise and a powerful low oomph.

@LievenDV

Schmitt_High-Gain-Amp-by-LievenDV.json (53.2 KB)

[gianfranco]

Hailstorm | high gain based on EVH 5150 III 100W by @LievenDV

@LievenDV

Based on an SVT version of the EVH 5150 III 100W
High gain channel

@LievenDV

Hailstorm-high-gain-by-LievenDV.json (53.3 KB)

[gianfranco]

Ibanez TSA5TVR by @malfunction54

@malfunction54

I profiled my little Ibanez 5W tube amp. When paired with a Jensen C8R IR, it sounds reasonably close to the real thing. This profile is clean, but I recorded on max volume. It is fairly easy to push into breakup. Treble at 10 o’clock, bass at 2 o’clock, built-in spring reverb off, and built-in TubeScreamer circuit off.
Ibanez TSA5TVR.json (171.3 KB)

[gianfranco]

JMP low sensitivity Pedal Platform by @mreed707

@mreed707

https://forum.mod.audio/uploads/short-url/eNi7sXKpyz9KVjhCEWQqWBnDKjF.json

JMP low sensitivity input pedal platform