List of shared models

[gianfranco]

Fender Blues Deluxe (reissue) by @TheRedOne

@TheRedOne

all the models here are based on the clean channel, with treble, mid and bass knobs at 6, 8 and 6 correspondingly (the way I set 'em at gigs).
I used an Oktava mk-519 condenser mic and Sennheiser e906 dynamic mic.

The models:

Preamp (no cab)

Fender Blues Deluxe 1 - preamp.json (176.0 KB)

Condenser mic on-axis close up

Fender Blues Deluxe 2 - pre+cab condendser mic on-axis.json (175.5 KB)

Condenser mic off-axis close up

Fender Blues Deluxe 3 - pre+cab condendser mic off-axis.json (176.0 KB)

Condenser mic on-axis 30cm from the cone

Fender Blues Deluxe 4 - pre+cab condendser mic on-axis 30cm off.json (175.3 KB)

Condenser mic off-axis 30cm from the cone

Fender Blues Deluxe 5 - pre+cab condendser mic off-axis 30cm off.json (176.0 KB)

Dynamic mic on-axis

Fender Blues Deluxe 6 - pre+cab dynamic mic on-axis.json (176.2 KB)

Dynamic mic off-axis

@TheRedOne

Then I took the pre-amp signal as an “input.wav” for the model, and the same respective mic’ed cabs as targets, to get the "cab only" models, to use two Aida-X plugins in the chain, one with the preamp model and the other with the “cab only” model loaded to imitate four-cable fx send/return setup, so I can put some pedals before the preamp, and some - in between the preamp and the power amp of the cabinet.

4-cable setup

@TheRedOne

Surprisingly it works, and if you A/B compare a “pre+cab” model and a “pre” model to a respective “cab only” model, well, at least I was not able to hear much difference in a blind test. Try it out yourself and let me know if it works for you.

A/B test setup

Here are the “cab only” models to be used with either the preamp model above or, I guess, any other “preamp only” model.

Condenser mic on-axis close up

Fender Blues Deluxe 2a - cab only condendser mic on-axis.json (175.5 KB)

Condenser mic off-axis close up

Fender Blues Deluxe 3a - cab only condendser mic off-axis.json (175.7 KB)

Condenser mic on-axis 30cm from the cone

Fender Blues Deluxe 4a - cab only condendser mic on-axis 30cm off.json (175.8 KB)

Condenser mic off-axis 30cm from the cone

Surprisingly, after like 20 or 30 attempts to train a model with a decent ESR (in my experience - anything less than 0,04), I just couldn’t make it. All the resulting models came out with ESR around 0,07 and were quite noisy. After a few sleepless nights I just gave up. Sorry, no model here!

Dynamic mic on-axis

Fender Blues Deluxe 6a - cab only dynamic mic on-axis.json (176.7 KB)

Dynamic mic off-axis